rvNetLinx Logo
bulletin board
Onan Emerald2 cuts out after start released



[ Follow Ups ] [ Post A Follow Up ] [ Posting Page ] [ FAQ ]


Posted by darren.dorgan on October 07, 2001 at 14:53:54:

My Onan Emerald 2 (BGE) cuts out when I release the start switch.
I have bypassed the oil pressure switch, and this made no difference. Also I checked the 2 resitors (5ohm and 1.5ohm) which are both OK. The only brushed I can see are right at the end of the generator, and they are both OK. I measured the resistance across both the commutators and I get approx 22ohm, so I'm assuming the windings are OK, but I get no voltage reading from these which seems strange. The brushes definately make contact, since I can measure the winding resistance even through the wiring to the brushes. Not sure if this is my problem or it is something else. Seems strange I get no voltage here though.
Any help greatly appreciated.

Darren



Follow Ups:


Post A Follow Up

Name:
E-Mail:
Subject:
Message:

If you would like to include a link to another page with your message,
please provide both the URL address and the title of the page.
Optional Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post A Follow Up ] [ Posting Page ] [ FAQ ]