rvNetLinx Logo
bulletin board 		Re: Onan Emerald II (BGE) starts but stops when button released


[ Follow Ups ] [ Post A Follow Up ] [ Posting Page ] [ FAQ ]

Posted by Ismo on October 08, 2001 at 23:09:17:

In Reply to: Onan Emerald II (BGE) starts but stops when button released posted by Darren Dorgan on October 07, 2001 at 17:27:02:

: I've checked the oil pressure switch and it's OK. The only brushes ( 2 of them) I can find are at then end of the generator. The resitance between the two commutators is about 22ohms, and the brushes themselves are OK, although I do not pick up any AC/DC voltage from them, even though the wires are also OK.

: Are these supposed to be 12V ? - At one point thought I was picking up 10V DC from them, but then the next time I started up there was nothing again. Also if I give the coil I direct supply the engine keeps running, but I obviously don't want to do that.

: Any help greatly appreciated.

: Darren
On an Onan be sure to mention the complete model number.If it has an electronic voltage regulator that could be the problem,it's in the compt. behind the starter switch. If not more than likely the starter pc board behind the switch. There is some more info at the link in the forum area.



Follow Ups:

Post A Follow Up

Name:
E-Mail:
Subject:
Message:

If you would like to include a link to another page with your message,
please provide both the URL address and the title of the page.
Optional Link URL:
Link Title:
Optional Image URL:

[ Follow Ups ] [ Post A Follow Up ] [ Posting Page ] [ FAQ ]